I have bought a T100R from e-bay. It was a shed find in Canada and currently has no registration number. The engine is seized and there are a number of parts missing. Here is a before and below is a copyright free picture of one that I would be aiming for in the long term.
photobucket.com
Engine and Frame Number match with numbers being PG 40533 T100R which makes it a November 1972 manufactured T100R.
Here is a photobucket entry of a really nicely done one.
Another one here.
Found this excellent site where someone did up a T100R in the states.
Shops I could use are
ebay
Tri Cor
http://www.britbits.co.uk/
Burton Bike Bits
Grint
TMS
The Parts catalogue is probably pretty near this one T100C 1971 or this one T100R 1973
Bits I need, I will stick part numbers on when I can
- Fork stanchions. 97-3904
Tank Badges 82-9700 and 82-9701Side Panel.ebay 6-5-2010- Rev Counter (Black face).
- Speedo. (I have a speedo to PX or repair).
- Seat Trim.
- Headlight bulb
- Rear light plastic lens.
- Silencers. (need to track down which type needed).
- Exhaust pipes. (did this model have a balance pipe?
- Side stand.
- Centre stand. (I have a bonnie one that will fit for now).
Stainless steel Allen head screw set.- Headlight mounting brackets.
- Battery.
- Bulbs.
- Chain.
- Wheels stainless steel spokes and rims.
- Brake shoes.
- Air Filters.
- All Cables.
- Centre of Tank Chrome Trim.
- Clutch Lever.
- Brake Lever.
- Choke Lever
- Handle Bars.
Fuel Taps.- Fuel Cap.
Oil Pump. One in engine seems fine- Colour Scheme paint cherry red and white.
- Passenger foot pegs.
Front Mudguard.EBay 23rd May 2010 19.99 + 7 pp + 1 charity- Grab Rail. (Goes behind seat).
Engine
I have not at this point taken the engine out but when I take it apart I will almost certainly need much of the following list.
Stainless steel engine set.- Valves (Probably from http://www.gsvalves.co.uk)
- Inlet (2 Needed) GS Part No V265 Original Part No E6853
- Exhaust (2 Needed) GS Part No V266 Original Part No E6854
- Springs.
Pistons and rings.Primary Chain.- Clutch Plates.
- Clutch Rubbers.
- Main Bearings (Both sides).
- Shells for big end.
Little end pins.- Valve Guides.
Tappets.


Big project there! But when you get it to look like the bottom picture, it'll be amazing!
ReplyDelete